Quick Answer: Can You Change Oil Without Removing Drain Plug?

What size wrench Do I need to remove the oil drain plug?

A 13mm or a 15mm wrench is required when it comes to removing the most common drain plugs.

These two sizes are the most commonly used lengths in car maintenance in general as well..

How much does it cost to replace an oil plug?

Replacing an oil drain plug gasket will usually cost somewhere in the neighborhood of $25 to $35.

Do you need a torque wrench for oil change?

The general rule is “hand tight,” or about as tight as you can get the bolt just turning the ratchet with your wrist. If you are new to changing your oil though, use a torque wrench and the proper factory torque specs. It’s easy to over-tighten a bolt and strip the threads if you don’t have practice.

Are oil leaks common?

No, a few drips every now and then are perfectly normal. If your car is leaking oil fast, you should notice large puddles, as well as a dropping level. The only smoke that should come from your car is exhaust fumes, and they should only come out of the tailpipe.

How do you loosen a tight drain plug?

You’ll need to spray penetrating oil on the oil plug and leave it to sit for several hours. Then you can take a small hammer and tap counterclockwise to ensure that you are loosening the plug.

Can you drive with an oil leak?

The first sign of an oil leak isn’t necessarily a major problem. Once you determine you have adequate oil in your engine, it is possible to continue driving in the short term. It’s always best to treat an oil leak as soon as possible, however, to ensure a larger oil leak doesn’t catch you off guard.

What do I do if my oil drain plug is stripped?

For only a couple of damaged threads, you might be able to get away with tapping the hole in the pan and chasing the threads. If it’s worse, you’ll have to drill, tap and install a HeliCoil. Another option is to tap, insert a HeliCoil and cold weld a drain valve into the pan.

Can you pump oil out of a car?

Some models not only suck the oil out, but they can then pump it out of the reservoir into recycling containers, a handy feature. Hand pump models seem to create plenty of suction for passenger vehicles, so electric pumps or vacuum-powered extractors may not be necessary.

Can you drain your oil through the filter?

No. Removing the filter only removes the oil in the filter and less than a liter of oil in the lines going to the filter housing. If you really want to change your oil without pulling the plug out of the oil pan there is a tool for that. … It works by shoving a hose down the dipstick tube and vacuuming the oil out.

Why is my oil leaking after the oil change?

One of the major reasons why an engine leaks oil after an oil change is from rotted engine gaskets, oil seals, or bad connections. If you get under the car, check the oil pan seals and oil pan drain plug. You’ll then want to check the timing cover seal and valve cover gaskets to see what shape they’re in.

Can an oil drain plug fall out?

Can an Oil Drain Plug Fall Out? The answer is yes. If the Oil Drain Plug was not tightened properly after the oil was drained, it will eventually fall out.

Should you change oil drain plug?

You definitely do NOT need anew drain plug at every oil change. Depending on the vehicle , you MAY need a new crush washer at every change ( gasket). If you have been told that you need to replace both at every change by a dealer, quick change place or other, you have been being ripped off.

What happens if you don’t fix an oil leak?

What will happen if I ignore an oil leak? If you ignore that oil leak (we’ve all done it – hoping, wishing and praying it will magically disappear), your car will keep running until the oil runs dry. Without it, the engine will be damaged and may seize up. The key is to check the level of your oil.

How hard is it to change your own oil?

For most vehicles it is not too difficult. You’ll need a wrench or ratchet and socket plus an oil filter wrench. A pan to catch oil is a must as well. Modern cars are getting more and more difficult to change oil on due to underbody covers and terrible locations for filter and plugs.

What causes a stripped oil drain plug?

It’s stripped because someone either cross-threaded it or put it on too tight. As for being old!!.. If the oil change is done correctly then the oil pan and bold threads should last as long as the rest of the engine. … That means a lot of oil changes…the pan and bolt are fine.

What is the best oil extractor?

Our pick for the best oil extractor is the EWK Fluid Extractor Pump. It features pneumatic and manual modes and thus can be used anywhere and on a variety of automobiles. However, if you are on a tight budget, the Air Power America fluid removing system is a good choice. It is efficient, portable, and easy to use.

How tight should an oil drain plug be?

With a wrench tighten the plug very lightly until it stops and is only snug with the pan. Then tighten the plug 1/4 turn. That’s it your done. Don’t over tighten your engine oil drain plug.

Does oil drain plug need torque?

The warmer the engine, the quicker the oil will completely drain. Replace the drain plug and tighten it to 20 ft-lbs. … If you do not have a torque wrench, be careful that you do not overtighten the plug and strip the threads. The plug should be tight, but you do not need to exert excessive force to reach 20 ft-lbs.